Qiachip KR2401A DC6V-24V 1CHANNEL RECEIVER INSTRUCTION MANUAL

Function description and setting method               

* Note: All the following working modes need to be implemented with QIACHIP remote control (transmitter) and controller (receiver / wireless remote control switch). There is no guarantee that remote controls from other brands will work properly with our product.

Reset function:

Clear all matched remotes. When the data is cleared, all remote control can't make receiver work.

Settings reset:

After pressing the receiver's learning button 8 times, the receiver clears all remote control data in its memory. When the receiver's LED light flashes, the reset function is complete.

 

Description of the three working modes :

Working modes: 1) Momentary; 2) Toggle; 3) Latching;4)Delay.

 

  • Momentary mode:

After successful pairing in this mode, press and hold the remote control button (such as A), the corresponding relay on the receiver is turned on; release the remote control button (such as A), and the corresponding relay on the receiver will turn off.

 

  • Toggle mode:

After successful pairing in this mode, press the remote control button (such as A) to turn on the corresponding relay on the receiver; press the remote control button (such as A) again to turn off the corresponding relay on the receiver.

 

  • Latching mode:

After successful pairing in this mode, press the remote control button (such as A), the receiver relay corresponding  is turned on; press the remote control button (such as B), the relay on the receiver corresponding is turned off.

 

 

How to set the working mode of the switch controller?

The working mode can only be set when the  LED light indicators of the switch controller are lit.

 

Set Momentary mode :

Step 1) Press the receiver's learning button once.

Wait for the LED on the receiver to light on and enter the setting state.

Step 2) Press the button on the remote control (such as A) once. The LED on the receiver will flash and then turn off. The Momentary mode is set successfully.

 

Set Toggle Mode:

Step 1) Press the receiver's learning button twice.

Wait for the LED on the receiver to light on and enter the setting state.

Step 2) Press the button on the remote control (such as A) once. The LED on the receiver will flash and then turn off. The Toggle Mode is set successfully.

 

Set Latching Mode:

Step 1) Press the receiver's learning button 3 times.

Wait for the LED on the receiver to light on and enter the setting state.

Step 2)Press the button on the remote control (such as A) once. The LED on the receiver will flash and then lights up.

Step 3) At this time, press another button (such as B) of the same remote control, the indicator flashes and then turn off. The Latching Mode is set successfully.

 

 

TECHNICAL DATE                                

Input Power

DC 6V-24V

RF Frequency

433.92MHZ or 315MHZ

Standby Current

5mA

Load power

800w

Receiver sensitivity

>97dbm

Operation mode

Momentary Mode,Toggle Mode,Toggle Mode

Output

NO , NC , COM

Support remote type

Learning code (1527)

Modulation mode

ASK

Working temperature

-10 ~ +80

Size

35*30*18mm (mm)

 

 BUY NOW


Older Post Newer Post


Leave a comment

Please note, comments must be approved before they are published