Qiachip 433MHz Wireless Remote Control Switch DC 6V 12V 24V 1CH 10A Relay Receiver Module controller KR2401F KT01 KT05
Module:
Remote Control（Transmitter module）：KT05-4-AB (include battery )
Model Number: KT05-4-AB
Operating Frequency: 433MHz
Power by 3V Coin Cell Button Battery (Battery included )
Material: PVC
Button: 2 Buttons
Size: 59mm x 28mm x 8mm
Operating Voltage: 3V
Operating Current: 12mA
Transmitting Power: 10mw
Modulation Mode: ASK (AM)
Encoding Type: Learning
Transfers Distance: 20-50 m
Product Type: KT01-117S-4
RF Frequency: 433 Hz
Channel Supported: Four Channel
Encoding Type: Learning Code(1527)
Modulation System: ASK
Operating Voltage:DC12V
Operating Current: <25mA
Transmitting Power: +13dbm
Frequency Windage: +0.2MHz
Transmission Distance: 50m (Free Space)
Color: Black
Size: 5.4 * 2.9 * 0.9cm
Weight: 26g
Specifications Of The Receiver:
Model: KR2401A-4
Product Type: 1-Channel Remote Control Switch
RF Working Mode: ASK Superheterodyne Reception
Modulation Mode:ASK
Working Mode: Momentary/Toggle/Latched, etc.
Matching Mode: Intelligent Learning Code 1527.
Power: Wide voltage 5V-24V
Quiescent Current:5mA
Working current: 10A
Maximum load power: 300W
RF Frequency: 433MHz
Wiring method: NC COM NO
Circuit Board Size: 22 * 35 * 50mm
About Working mode:
* Note: All the following working modes need to be implemented with QIACHIP remote control (transmitter) and controller (receiver / wireless remote control switch). There is no guarantee that remote controls from other brands will work properly with our product.
Reset function:
Clear all matched remotes. When the data is cleared, all remote control can't make receiver work.Settings reset:After pressing the receiver's learning button 8 times, the receiver clears all remote control data in its memory. When the receiver's LED light flashes, the reset function is complete.
Description of the three working modes :
Working modes: 1) Momentary; 2) Toggle; 3) Latching;4)Delay.- Momentary mode:
- Toggle mode:
- Latching mode:
How to set the working mode of the switch controller?
The working mode can only be set when the LED light indicators of the switch controller are lit.
Set Momentary mode :
Step 1) Press the receiver's learning button once.Wait for the LED on the receiver to light on and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the receiver will flash and then turn off. The Momentary mode is set successfully.
Set Toggle Mode:
Step 1) Press the receiver's learning button twice.Wait for the LED on the receiver to light on and enter the setting state.
Step 2) Press the button on the remote control (such as A) once. The LED on the receiver will flash and then turn off. The Toggle Mode is set successfully.
Set Latching Mode:
Step 1) Press the receiver's learning button 3 times.Wait for the LED on the receiver to light on and enter the setting state.
Step 2)Press the button on the remote control (such as A) once. The LED on the receiver will flash and then lights up.
Step 3) At this time, press another button (such as B) of the same remote control, the indicator flashes and then turn off. The Latching Mode is set successfully.