How to use QIACHIP receiver module RX480E ? How to set the working mode of RX480E

Latched Latching Momentary Receiver Module RF RX480E Toggle User manual

About working mode:
Momentary (Inching Mode): Push the remote button, the relay connects, release the remote button, the relay dis-connects.
Toggle (Self-Lock Mode): Push once the remote button, the relay connects, push twice the remote button, the relay dis-connects.
Latching (Interlocked Mode): Push the remote button A, the relay connects, push the remote button B, the relay dis-connect.

How to use:

Reset method: Push the learning button on the receivers for 8 times, the codes will be cleaned.
After clearing the code, all the remote control cannot work anymore.

The setting of working mode:

1. Momentary Mode: pressing one time the learning key button on the receiver board ( Led indicator on receiver board will signaling simultaneously ),then press any of the remote button , signaling three times by remote’s LED indicator informs about setting momentary mode successfully .
2. Toggle Mode: pressing two times the learning key button on the receiver board( Led indicator on receiver board will signaling simultaneously ),then press any of the remote button , signaling three times by remote’s LED indicator informs about setting toggle mode successfully .
3. Latched Mode: pressing three times the learning key button on the receiver board ( Led indicator on receiver board will signaling simultaneously ),then press first remote button ,follow on second remote button , signaling three times by remote’s LED indicator informs about setting latching mode successfully ( first button stands for on , second button stands for off ).
4. 2CH momentary + 2CH Toggle : pressing four times the learning key button on the receiver board(Led indicator on receiver board will signaling simultaneously ),then press any of the remote button , signaling three times by remote’s LED indicator informs about setting successfully .
5. 2CH Momentary + 2CH Latched : pressing five times the learning key button on the receiver board ( Led indicator on receiver board will signaling simultaneously ),then press any of the remote button , signaling three times by remote’s LED indicator informs about setting successfully .
6. 2CH Toggle + 2CH Latched : pressing six times the learning key button on the receiver board( Led indicator on receiver board will signaling simultaneously ),then press any of the remote button , signaling three times by remote’s LED indicator informs about setting successfully .
7. 2CH Latching + 2CH Latched : pressing seven times the learning key button on the receiver board( Led indicator on receiver board will signaling simultaneously ),then press any of the remote button , signaling three times by remote’s LED indicator informs about setting successfully .


Older Post


Leave a comment

Please note, comments must be approved before they are published