Qiachip KTRGB-17K-4&RXRGB-17K-4 17 Key RGB Light Remote control switch instruction manual

Model:KTRGB-17K-4&RXRGB-17K-4 

Instructions

• 22 Dynamic Modes
• 20Static Colors           
• Very Smooth Effects
• Speed Adjustable 
• Brightness Adjustable  
• Card Type RF Remote
• Ultra Slim Design
• Easy Remote Pairing
• Dynamic Demo Mode
• Direct Color Select

Functions

①.Turn On/Standby

Press this key to turn on unit or switch to standby mode. At power on, unit will automatically turn on and restore to previous status.

②/⑨.Dynamic Mode Adjust

Switch to dynamic mode from static color, or switch between dynamic modes.

③/⑩.Dynamic Speed Adjust

Adjust dynamic playing speed. Press SPEED+ to increase speed and press SPEED- to decrease.

④/⑤.Static Color Adjust

Switch to static color mode from dynamic mode, or switch between static colors.

⑥.Direct Color Select

Shortcut key to static colors. When press the specific color key, LED will play the same static color.

⑦/⑧.Brightness Adjust

Adjust static color brightness. Press BRIGHT+ to increase brightness and press BRIGHT- to decrease.

⑪.Demo Mode

Press this key will switch to Demo mode. At demo mode, it plays 17 dynamic modes in loop, each mode repeat 3 times.

Installing

1. Power supply

This unit accepts DC 12V, The DC jack’s inner pole is positive and sleeve is negative. Also please make sure the power supply voltage is same as the LED load.

2. LED Output

This unit support common anode connection LED products.

The mark ‘   ‘ indicates the common connection node.

（CAUTION! Do not short circuit or overload the LED outputs, this way lead to permanent damage!）

Operation

1. Using Remote Control

Please pull out the battery insulate tape before using. The RF wireless remote signal can pass through barrier, so it’s not necessary to aim at the main unit when operate.

2. Setting Remote and LED Controller 1 to 1 paired

（the remote control can directly with the RGB controller after removing the battery insulate tape.）

1 to 1 Paired：

1) Plug off the power of main unit and plug in after 5 seconds.

2) Press (SPEED-) and (SPEED+) key together in 5 seconds after power on. RGB LED Strip light Setting is completed after 3 flashes.

Free Remote Pairing Mode：

Press (COLOR-) and (BRIGHT-) key together in 5 seconds after power on. RGB LED Strip light Setting is completed after 3 flashes.

Specification