Qiachip KT16-KB 4 buttons RF 433MHz Copy Remote Control Duplicator Cloning Gate Garage Door Opener




Low cost - Referring to other duplicator, yeah;

Charming shape- Suitable for handheld;

Colorful - A red button is special;

Check before send -  Don't worry the quality issue!



2260(all manufacturers), 2262(All manufacturers),

PT2264, 5326(All manufacturers), SC5262, HT600,

HT680, HT6207, HT6010, HT6012, HT6014, SMC918series,

527(All manufacturers), 1527(All manufacturers),

2240(All manufacturers) .



It can't copy original car remote control, two-way remote control and rolling code remote control (Rolling code chips start with HCS commonly, such as HCS200, HCS201, HCS300, HCS301, etc.)



1.Clear Out Code:


Press the A button and B button at the same time, the LED indicator will enter into the fast flashing status, it means that all the memory data is cleared (Please see the video above). You can repeat the above operating steps if the memory clear operation is not successful.


2.Duplicating (Learning)/Face to Face Copying(One to One Copying):


After cleared the memory, you can operate Face to Face Copying(One to One Copying), your left hands press the original remote control and your right hands press the duplicating remote control at the same time; Put the two remote controls together as close as possible. For example, press the Button A of the 2 remote controls at the same time, the LED Indicator flashes fast, and you press the Button A of the duplicating remote control again, the LED indicator long light, it means that the original remote control of the A button A code has been copied into the duplicating remote control. The other 3 buttons are the same operation.




Older Post Newer Post

Leave a comment

Please note, comments must be approved before they are published